(888) 823-5247

Oil-Fired Boilers and Furnaces

Oil-Fired Boilers and Furnaces

Oil-fired furnaces and boilers are a popular choice in areas of the country with limited access to natural gas, such as the Northeast. Oil-fired furnaces and boilers present an opportunity to use renewable fuels to heat your home. A number of companies are now offering heating oil blended with biodiesel, allowing their customers to reduce their dependence on foreign oil while drawing on a domestic energy source. The biodiesel blends also produce less pollution than pure heating oil.

A number of retrofits are possible for oil-fired furnaces and boilers, but before pursuing any retrofits you should consider the potential added benefits you could receive by simply replacing the furnace. The following retrofits are possible:

Vent dampers

The most common retrofit is the addition of a vent (or flue) damper. A vent damper prevents chimney losses by closing off a boiler's vent when the boiler isn't firing. Steam boilers benefit from vent dampers more than hot-water boilers, and bigger boilers benefit more than smaller ones. Vent dampers, however, may not be cost effective with properly sized, newer furnace models. For older oil burners, converting to a flame retention burner (below) is probably a better investment.

Barometric flue damper

During your annual service checkup, have your technician perform a draft test. If too much heat is going up the chimney, you may need to install a barometric flue damper. The cost is less than $100 and could save you about 5% of your fuel cost.

Derating or replacing oil burners

Many boilers and furnaces in today's homes are oversized, particularly if you've upgraded the energy efficiency of your home. It is simple to reduce the heating capacity of your oil boiler or furnace to make it operate more efficiently by having a technician install a smaller nozzle. The cost is minimal and it could cut fuel bills by as much as 10%.

If you have an old, inefficient burner, though, you may want to replace the whole burner. A flame retention burner will block airflow up the chimney when the unit isn't running, saving up to 20% on fuel costs at a cost of about $500. Note that steam boilers should only be derated if the steam system is also modified to remove excess radiators, which is a tricky procedure.

Modulating Aquastats (for hot water boilers only)

An aquastat controls the temperature of the hot water in a boiler, typically keeping it around 180°F. But when heating needs a lighter in the spring and fall, that's actually higher than needed, and wastes energy. A modulating aquastat, also called an outdoor reset, senses outdoor temperatures and adjusts the hot water temperature accordingly. The units can save up to 10% of fuel costs, and cost several hundred dollars.

A cheaper alternative is to manually adjust the aquastat yourself, turning it down to around 120°F during the milder heating season. Consult your owner's manual or a service technician to locate the aquastat.

Time-Delay Relay (for hot water boilers only)

A time delay relay is a way to squeeze the most heat out of your system without running the boiler. When the thermostat clicks on, the relay causes the boiler to circulate hot water through the system without turning on the boiler. After a set time, the boiler will fire up. A time delay relay costs about $100 and can cut your fuel costs by up to 10%.


U.S. Department of Energy

24 Hour Emergency Service • Call Us Today • (888) 823-5247 • or • Fill Out Our Online Form
24 Hour Emergency Service
Call Us Today
(888) 823-5247
Fill Out Our Online Form
Send Us a Message
 
 
Payment Options
 
 
For furnace in Bowie MD, we accept most major credit cards.
We accept cash for heating repair service provided in Crofton MD.
We accept check for heat pump repair service provided in Annapolis MD.
Belair Engineering and Service Company, Inc. accepts all major credit cards, cash, and local, personal checks. We also offer a variety of financing options. Contact us for more information
 
Connect With Us
 
Belair Engineering and Service Company, Inc. is the 2017 Capital Readers Choice Winner!
Contact Information
 
Belair Engineering and Service Company, Inc.
Address:  15881 Commerce Court
 Upper Marlboro, MD 20774
Phone:     (301) 249-0300
Toll Free:  (888) 823-5247
Fax:         (301) 249-0302
Belair Engineering and Service Company, Inc.
Address:  15881 Commerce Court
Upper Marlboro, MD 20774
Phone:     (301) 249-0300
Toll Free:  (888) 823-5247
Fax:          (301) 249-0302
Schedule Service
Home   |   Email Us   |   Schedule Service   |   Get a Quote   |   Ask a Tech   |   Maintenance   |   Employment   |   Privacy Policy
GBCC member, Belair Engineering is the boiler & heat pump repair service in Bowie MD. We are a proud ACCA member, so trust us with your furnace repair service in Annapolis MD. Associated Builders and Contractors for better heat pump and furnace repair service in Bowie MD. Heating and air conditioning contractors in The Crofton Chamber of Commerce; Trust them with your boiler unit repair in Bowie MD. Get a Energy star heat pump installation done by Belair in Bowie MD. Heat Pump & boiler repair service in Bowie MD. Generators & boiler Unit repair service in Crofton MD. Nate member for better heat pump repair service in Crofton MD. Be Eco friendly with a boiler Unit installation in Crofton MD. Lead safe heat pump and furnace repair or installation in Bowie MD. Come see the Gas fireplace inserts & gas fire logs installation in our Bowie MD showroom! Hearth patio & barbecue repair service in Expo in Crofton MD. NCI member to help furnace repair service in Bowie MD. Service Roundtable member; heat pump service and heating repair in Annapolis MD.